Posts Tagged "fitting"

Erde 143 hard top fitting instructions

Here is a guide to fitting a hard-top cover to an Erde 143 trailer. There are pre drilled holes at each side of the top edge of the rear panel, they may be covered by plastic studs that will need to be removed. Remove all plastic studs even though you will only be using the […]

Erde cycle carrier fitting guide

Here is a guide that will help you fit cycle carriers to an Erde trailer. Please remember that you must have loadbars or a hard-top cover with loadbars installed on your trailer in order to fit cycle carriers. It is also possible to fit these to some car roof racks. Start by slotting these square […]

Load bar fitting guide for an Erde hard-top cover

Here is a guide to fitting load bars on a hard-top cover for an Erde trailer. First of all you will have to reinforce the body panels of your trailer so they can handle the extra weight. The example we are using is an Erde 142, please be aware that this process may vary slightly […]

Erde 142 hard-top fitting instructions

Here is a guide to fitting a hardtop cover to an Erde 142 trailer. Below is everything you will need from the hard-top kit. There are some pieces in the kit that are used when fitting this cover to other models of Erde trailer. When fitting it to a 142 trailer however, you will only […]

Erde waterproof high-cover fitting instructions

Erde waterproof high-covers are quite simple to install. Here is a set of fitting instructions to help simplify it further. First of all you should remember that the 102, 122 and 142 are slightly different to the rest of the Erde range. The 143 model trailer and above have black plastic caps covering holes in […]

Triple lock towing head fitting instructions

Here is a guide to replacing a standard coupling head with a ‘triple lock’ style coupling on a 50mm box section drawbar. Below is a triple lock head kit. This comes with all the nuts and bolts needed to fit it, but there are a few other things you will also need. You will need […]

Erde 122 hard-top cover fitting instructions

Here is a guide to fitting a hard-top cover to an Erde 122 trailer. First you will need to reinforce the front body panel of your trailer. Take one of the reinforcement plates supplied with the cover, this will need to be slotted under the lip at the top of the front panel. There should […]